Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All,When trying to play/share a Video over webex (i.e from Youtube), the audio is not shared. Normally you have the 'Optimize for motion and video' which allows you to 'Share Audio' but it is missing on my customers setup. Has anyone experience...
Hello All,
I have just setup a SIPGATE (SIP) account and have out bound calls working. I am using Callmanager 10.5 and CRS1000v (As cube), both built in VMWare 5.5.
My problem is with inbound calls from SIPGATE. I get invite 103 messages using 'debu...
Hello All,I currently have callmanager, unity and Imp on 10.5 and want to add webex. Have done some research but still unsure how to proceed.Does anyone know if a training video exists please. Also do I just build an ova on vsphere?Any help or guid...
Hello All, I have a few Cisco 7821 handsets that will not allow DTMF tones to pass to things like on-line banking. i.e "press 1 for x, press 2 for y", when i press "1" i hear the tone but the other end does nothing.It works with most other phone typ...
Hello all,Does anyone have a decent document on how to replace a cisco 3800 SRST gateway on version 12 with a 2921 on version 15 please?Not sure if there are any gotchas etc.We also want to use a loopback as the SRST reference. Running v7 callmanager...
Hello All,After posting the Question i have found a document which states the following:~"Optimizing for motion and video requires Cisco Webex video platform version 2.0"I think here lies the problem. Thanks anyway
Hello All, When upgrading from 8.6 to 11.x, instead of using 'disc expansion' COP file, could i not just build new VM with correct specs and then DRS current 8.6 to new VM, then upgrade to 11.x? Cheers in advance.
Hi Gary,
Many thanks for the trace. The problem has now been spotted and fixed.
I had no 'trusted devices' in my trust list hence the calling party was not allowed onto the cube. After adding the correct trusted ip address's the trace look very simil...
