cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
646
Views
5
Helpful
4
Replies

qsic trunk between ccme and nec pbx

tkavithas87
Beginner
Beginner

hi,

i need to configure qsic trunk between ccme and pbx.i want the configuration for qsic on ccme.does any one have the configuration?how the dialpeer should be configured?

4 Replies 4

paolo bevilacqua
Hall of Fame
Hall of Fame

Wrong forum, post in "voice - IP telephony". You can move your post using the actions panel on the rignt.

thanks paola for the information

Hi,

I have looked through the Cisco Interoperability Portal

This link is as near to what config you need as I can find

http://www.cisco.com/en/US/solutions/collateral/ns340/ns414/ns728/ns829/625258.pdf

You may need you look at changes like E1 for T1 etc

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.

thanks alex.it is helpful.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: