08-14-2012 08:34 AM - edited 03-16-2019 12:42 PM
hi,
i need to configure qsic trunk between ccme and pbx.i want the configuration for qsic on ccme.does any one have the configuration?how the dialpeer should be configured?
08-14-2012 02:32 PM
Wrong forum, post in "voice - IP telephony". You can move your post using the actions panel on the rignt.
08-16-2012 05:57 PM
thanks paola for the information
08-17-2012 05:58 AM
Hi,
I have looked through the Cisco Interoperability Portal
This link is as near to what config you need as I can find
http://www.cisco.com/en/US/solutions/collateral/ns340/ns414/ns728/ns829/625258.pdf
You may need you look at changes like E1 for T1 etc
Regards,
Alex.
Please rate useful posts.
08-20-2012 06:05 PM
thanks alex.it is helpful.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide