cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Walkthrough Wednesdays
389
Views
0
Helpful
4
Replies
tkavithas87
Beginner

qsic trunk

  i am trying to  configuredqsic trunk between cme and panasonic pbx.but the controller is down.here is the show command.

cme#show controllers e1

E1 0/2/0 is down.

  Applique type is Channelized E1 - balanced

  Transmitter is sending remote alarm.

  Receiver has loss of signal.

  alarm-trigger is not set

  Version info Firmware: 20100222, FPGA: 13, spm_count = 0

  Framing is CRC4, Line Code is HDB3, Clock Source is Internal.

  Data in current interval (649 seconds elapsed):

     0 Line Code Violations, 0 Path Code Violations

     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins

     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 649 Unavail Secs

  Total Data (last 24 hours)

     0 Line Code Violations, 0 Path Code Violations,

     0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins,

     0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 86400 Unavail Secs

what could be the reason?

thanks

kavi

4 REPLIES 4
Leo Laohoo
VIP Community Legend

Duplicate post #1.

Chris Deren
Hall of Fame Master

Try different cable and crossover.

Sent from Cisco Technical Support iPhone App

Hello,

make CME trunk as master and panasonic as salve , waht you are using here , can you paste show isdn st here . here it alos shows loss of signal , check yr cabling aprt too

rgds

Amim

      

if this helps, please rate

hi,

and make sure you use all 30 channel of E1 ,as sometime it does not worked with fragmneted channel .

rgds

AMim

      

if this helps, please rate

Content for Community-Ad

Spotlight Awards 2021