02-10-2011 10:15 AM - edited 03-16-2019 03:23 AM
Hey everyone,
I am trying to order an additional inbound/outbound voice E1 PRI (probably R2) to act as a hot standby if the existing E1 fails. Telmex claims they can provide the additional circuit, but a manual failover would be required for the secondary to take over for the active E1. This means we have to call Telmex to make the switch which is not ideal.
Maybe we are not asking Telmex for the correct product. I figured in the Telco world, this would just be called a "trunk group". Can anyone say if they are doing this already with Telmex in Mexico, and what this service is called?
Thanks in advance
02-17-2011 08:49 AM
Hi
I thought it would build a trunk-group to 2xE1, and increase the circuit you are using 30 to 60 ports, it certainly more expensive but you will have the redundancy you need.
can send me a diagram of the topology?
02-17-2011 12:08 PM
02-18-2011 12:17 PM
02-18-2011 12:20 PM
Hello Diego,
My problem is I cannot obtain a trunk group (2xE1) from Telmex in Mexico.
My question is not about the configuration on the Cisco side.
But thanks.
-Steve
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide