Hello,
I've got a non-standard, and from what I gather non-supported, configuration that I am trying to get working. In one of my sites, there is a room with no data jack and no easy way to get it there. So I am trying to hook a phone up wirelessly.
Here is my setup:
Main site with a UC560 & 20 7942 Phones
Remote site with SR520, Site-to-Site VPN to Main Site & 10 7942 Phones
In my remote site, I have a Cisco Access point installed and configured to connect to the data vlan. I have a 7962 phone hooked up to the ethernet port on the access point. A power brick is powering the phone. When I boot up the phone, it connects to the UC560 and downloads the latest firmware but after upgrading, it gives an error updating locale and never registers.
Is there anything that I need to do on the UC560 or SR520 to get this working? I understand that call quality might not be good since I don't believe there will be any QoS, but I have a stubborn client that want me to try and get this to work.
In theory, the phone should register correct?
-Brian