Route Pattern query

[singh-ashok]

I am trying to configure a Route Pattern for the range 72425 - 72524... I configured 72[45]XX. Is there a better / shorter way to do this ?

[phooghen]

I don't think there is a shorter way to do this.

There is probably a better way to limit the range by creating multiple Route Patterns but I don't think this is what you are looking for.

Pierre.

[singh-ashok]

Pierre,

Yes you are right. I was just trying to find out if I had a way to consolidate this range into one RP & avoid configuring multiple ones.

Best Regards,

Ashok.

[JATINDER KUMAR]

i doubt u r correct on 4th digit...

becoz it can take values less then 25 also.. please see if u want that

Jatin

[singh-ashok]

Jatinder,

You are right. I had this doubt too. That's why looking for expert opinion.

[Jaime Valencia]

You cannot configure that in just 1 statement, you need at least 4 patterns to cover that range, your lower and upper limits cause a lot of problems when it comes to summarizing.

You need to cover this 4 ranges each with 1 route pattern.

72425-72429

72430-72499

72500-72520

72521-72524

HTH

java

If this helps, please rate

www.cisco.com/go/pdihelpdesk