router 2811 with two PVDM, (PVDM2-16 'n' 2-32), but voice-card 0 showing

[rammany19]

hello

i have two pcs of PVDM2 in cisco router 2811, but its only voice-card 0 showing, how can i configure the second one which suppose to be voice-card 1?

[dkemp]

rammany19,

     The "voice-card 0" is the 2 PVDM slots on the motherboard (both PVDM slots).  Voice slot 1 would appear when you add a voice NM into slot 1.

Cheers

Dave

[rammany19]

How do i share resources with 2pcs of PVDM, is it with their serial number using "show inventory" command?

[dkemp · Accepted solution]

They should already be pooled.

(basic voice card config)

voice-card 0

no dspfarm

dsp services dspfarm

then for example if you are doing transcoding

dspfarm profile 2 transcode

maximum sessions ?

the "?" will indicate how many DSP resources are available (this will be half as 2 DSP's are required for each complex transcoding session)  But it will give you an indicator that you are seeing all you resources.

Cheers

Dave