OK, I think this will work, but don't have the paging horns to test my theory.
Scenario: I have a customer that has overhead paging setup across Valcom horns via a V-9970 paging controller connected to an FXS port (x9100). They also have ephone-dn internal paging groups to page to specific sets of folks, as well as a combined all page (x9200) via ephone-dn configs.
Customer has asked to be able to include the overhead (analog) paging as part of the all page. If I set this up via stcapp, configuring the port appropriately and the ephone-dn and analog ephone, shouldn't I be able to configure the x9100 to still come across horns only, and have the x9200 all page blast on all the speaker phones as well as the horns?
Thoughts?
Kevin