- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-08-2018 02:14 AM - edited 03-17-2019 01:33 PM
Hello everyone,
I am looking for a method of rebooting group of phones on a defined set interval. The Cisco 8831 conference phones experience the call quality issue while being working for longer period of time (around a week). The reboot seems to fix the problem for a couple of days. The phone cannot be downgraded as the previous software release has the "under the water issue". The device is running the newest version 10.3(1)SR4b. I wonder if CUCM has any feature where you could schedule the reboots on set time interval. Thank you in advance for any advice.
Regards,
Daniel
Solved! Go to Solution.
- Labels:
-
Other IP Telephony
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-08-2018 06:12 AM
You can schedule BAT job that runs at specific days/times.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-08-2018 06:12 AM
No, CUCM doesn't have such feature, you could script a shut/no shut on the port on the switch to do this.
java
if this helps, please rate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
10-08-2018 06:12 AM
You can schedule BAT job that runs at specific days/times.