SIP/2.0 404 Not Found Error on Incoming Calls

[Abayomi Smith]

Hi All,

I would appreciate any help concerning this issue.

I am unable to make or receive calls. I receive SIP/2.0 404 Not Found on incoming call.

My setup is as thus;

CUCM-----------CUBE----------SIP Gateway

Please find attached part of the config of the CUBE and also output of debug ccsip message of test call from 02071871717 to 02038897551.

Regards,

Y.

[Suresh Subramanian · Accepted solution]

Called Number=02038897551. The significant digits field is set to ALL.​

So, you have translation pattern configured to convert the called number to internal extension? 

How are the internal extensions configured and assigned to the phones? 

[Abayomi Smith]

Thanks Suresh,

The called party transform mask was missing for the incoming translation pattern though it was there previously, I must have taken it off during troubleshooting and forgotten to put it back on.

Many thanks for pointing me towards this. Much appreciated.

Regards,

Y

[Suresh Subramanian]

Hi, seems you haven't collected the logs completely, so please collect the logs in buffer and attach the file. 

Check this thread on how to collect logs safely.

https://supportforums.cisco.com/document/62906/how-properly-and-safely-collect-debugs-ios-router