10-31-2016 09:22 AM - edited 03-17-2019 08:32 AM
Dear All,
I got two SIP gateways (Pri & Sec) for PSTN calling and I have put them in a route group for redundancy.
Requirement:
when primary circuit run out of bandwidth I want all calls to route through secondary.
Do I need to configure anything here to achieve this task or is this a default behaviour of route group?
Thanks in advance
Regards,
Syed
10-31-2016 09:39 AM
You will need to define how the "out of bandwidth" is tracked, here are some options for you:
https://supportforums.cisco.com/document/71326/call-admission-control-cac-implementation-cube
10-31-2016 09:43 AM
Hi Syed,
This is a default behaviour when I checked in my lab for CUCM v 10.
Check the following option below under Service parameters:
* Stop Routing on Out of Bandwidth Flag
Ensure this is set to False.
Regards,
Hitesh
10-31-2016 09:49 AM
Thanks Chris & Hitesh.
I am running on CUCM 8.5.1. I shall try this and come to you.
Thanks again
10-31-2016 09:59 AM
Well, there is a distinction between out of bandwidth in CUCM from CUBE here, if you set CAC on CUCM then the only way to re-route would be via AAR which you do not want to for this type of failover, hence my suggestion to control it on CUBE.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide