Hello everyone, i've asked this question many times during my calls with Cisco Support, but no one was able to give me an answer.
I set up about 100 SIP phones, they are 8961 phones and all of the are working, paging has been set up as well and it works also. However if i am on the phone paging cuts right through the conversation and it is very annoying to say the least,
Can any one assist please
This is what i have for paging
ephone-dn 5
number 200 no-reg primary
description IP-Paging
name Paging All Phones
paging ip 239.1.1.5 port 20480
TIA