Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
573
Views
0
Helpful
1
Replies

SIP Trunk Dial Tune Issue

jahanzaib amin
Level 1
Level 1

‎03-02-2014 05:05 AM - edited ‎03-16-2019 09:58 PM

Dear Team,

I am facing an issue on my IP Telephony Network. When i make call to any PSTN number than I didn't hear the Dial toner until some one pick the call

and same issue to make Inbound call from PSTN. Any one call to my Network from PSTN didn't hear the dial toner until some one pick the Ph. We have

SIP trunk to Cisco Gateway.

Can any one sugest what are the possible causes for this kind of issue?

Thanks

Jehan

Labels:
0 Helpful
1 Reply 1

Manish Prasad
Level 5
Level 5

‎03-02-2014 08:18 AM

Hi Jehan,

Configure "early-offer forced" under sip on VGW.

Collect debug ccsip message for inbound and outbound call separately and attach is here with you Voice gateway SIP and dial-peer config.

Take a look at this thread for ringback issue... https://supportforums.cisco.com/thread/2154998

Thanks

Manish

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents