Hi
I am using Cisco 2811 router to converge 2 RTP streams of different codes. I have scenario as below:
SIP PBX-------g729------>CISCO2811-------g711------>CUBE
I am using the universal transcoder, it does kick-in but no rtp gets established. Could some one please advise?
here is the config:
voice rtp send-recv
!
voice service voip
allow-connections h323 to h323
allow-connections h323 to sip
allow-connections sip to h323
allow-connections sip to sip
no supplementary-service h450.2
no supplementary-service h450.3
supplementary-service h450.12
fax protocol pass-through g711alaw
h323
h225 h245-address on-connect
sip
bind control source-interface FastEthernet0/1
bind media source-interface FastEthernet0/1
!
!
!
voice class codec 10
!
voice class codec 100
codec preference 1 g729r8
codec preference 2 g729br8
codec preference 3 g711ulaw
codec preference 4 g711alaw
!
!
!
voice-card 0
dsp services dspfarm
!
!
interface FastEthernet0/0
ip address 62.215.x.x 255.255.255.248
ip nat outside
ip virtual-reassembly
duplex auto
speed auto
!
interface FastEthernet0/1
ip address 10.50.1.42 255.255.255.252
ip nat inside
ip virtual-reassembly
duplex auto
speed auto
!
ip forward-protocol nd
ip route 0.0.0.0 0.0.0.0 62.215.231.49
ip route 80.184.x.x 255.255.255.0 10.50.1.41
!
no ip http server
no ip http secure-server
!
ip nat sip-sbc
ip nat inside source list 2 interface FastEthernet0/0 overload
ip nat inside source static 10.50.1.42 62.215.x.x
!
access-list 2 permit any
access-list 100 permit ip any any log
!
!
sccp local FastEthernet0/1
sccp ccm 10.50.1.42 identifier 1 version 3.1
sccp
!
sccp ccm group 1
associate ccm 1 priority 1
associate profile 110 register MTPNEW
!
dspfarm profile 110 transcode universal
codec g729abr8
codec g711alaw
codec g729ar8
codec g729r8
codec g729br8
maximum sessions 12
associate application SCCP
!
!
dial-peer voice 10 voip
description ***Outgoing Calls to SIP Trunk***
destination-pattern .T
modem passthrough nse codec g711alaw
voice-class sip dtmf-relay force rtp-nte
session protocol sipv2
session target ipv4:80.184.2x.y
session transport udp
dtmf-relay rtp-nte
codec g711alaw
fax rate disable
fax protocol pass-through g711alaw
no vad
!
dial-peer voice 2 voip
translation-profile incoming inbound
voice-class codec 100
voice-class sip dtmf-relay force rtp-nte
session protocol sipv2
incoming called-number .
dtmf-relay rtp-nte
no vad
!
!
!
telephony-service
sdspfarm units 1
sdspfarm transcode sessions 128
sdspfarm tag 1 MTPNEW
max-ephones 1
max-dn 1
ip source-address 10.50.1.42 port 2000
max-conferences 8 gain -6
call-forward pattern .T
transfer-system full-consult
transfer-pattern .T
create cnf-files version-stamp Jan 01 2002 00:00:00
!
