About saifuddin.miyaji

saifuddin.miyaji · 10-21-2024

We have configured hunt pilot/hunt list for hotline calls and distribute them to a group of agents. Ingress calls are coming in via ISP SIP Trunk terminated on the SIP Gateway C2900 Router. This Voice gateway has another SIP trunk towards the Callma...

saifuddin.miyaji · 06-02-2024

We have Cisco 9800 wireless controller with radius authentication with NPS servers. Its working as expected.Now, Im trying to copy the radius configurations from this controller to another one (Same model, same IOS version), it wont accept the radius...

saifuddin.miyaji · 01-04-2024

Hi,We have a cluster of Cisco Hyperflex systems and looking to replace two failed HDDs. These failed SAS drives are visible as "Blacklisted". Please advise if any special precaution is required while replacing these HDDs as I have seen some posts com...

saifuddin.miyaji · 01-14-2023

Hi, We are migrating to FPR 1010 from ASA 5500X series. Attached is the topology for the site to site VPN.The VPN tunnel established well and traffic is passing through.The challenge that we are facing is for the NAT on the the tunnel. We have very s...

saifuddin.miyaji · 01-11-2023

HiWe are trying to register a local gateway with Webex and not able to get through.- Webex hub has been configured as per the help.webex.com document. It generated the credentials like domain, registrar, username passwords, ect.- Credentials provided...

saifuddin.miyaji · 06-04-2024

Thank you Rich and Marce,Your suggestions have been useful in resolving this issue.Saif

saifuddin.miyaji · 06-03-2024

Hi Marce and Rich,Thank you for your valuable input on the subject.Where or are the 2 controllers running the same ios-xe version ? - Is the target controller on an older version perhaps ?Both the controller are on different versions, but the...

saifuddin.miyaji · 10-10-2023

The issue was these commands:voice class tenant 200 ... bind control source-interface g0/0/0 bind media source-interface g0/0/0It must be entered as :voice class tenant 200 ... bind control source-interface GigabitEthernet0/0/0 bind media sourc...

saifuddin.miyaji · 01-15-2023

Factory reset and reconfiguration has resolved the issue.

saifuddin.miyaji · 01-14-2023

Thank you for the suggestion. I have already gone through this document and configured accordingly.My problem is that there is an ugly looking IPV6 nat translation which is always hit first and so the manually created entries are not hit. This ipv6 n...

Member Since	‎09-18-2008 10:06 AM
Date Last Visited	‎01-19-2025 03:29 PM
Posts	202
Total Helpful Votes Received	66

User Statistics

User Activity

Hunt Pilot Caller ID

Cisco Catalyst 9800 Controller Type 6 Key/Password

Cisco Hyperflex HDD Failure

FPR 1010 NAT Issue

Webex Local Gateway Registration Issue

Re: Cisco Catalyst 9800 Controller Type 6 Key/Password

Re: Cisco Catalyst 9800 Controller Type 6 Key/Password

Re: Webex Local Gateway Registration Issue

Re: FPR 1010 NAT Issue

Re: FPR 1010 NAT Issue