Hey everyone,
I try to connect CME with Sipgate Trunk. For sipgate you need to send your sipgate user id as clid network-number. This works fine with a normale sipgate account because it has only numbers. But as a Sipgate Trunk Customer you get a user id with one letter inside, it's look like this: 1234567t1.
Is there any workaround to send this user id as the network caller-id?
dial-peer voice 1 voip
translation-profile incoming SIP-IN
translation-profile outgoing SIP-OUT
destination-pattern .T
session protocol sipv2
session target dns:sipconnect.sipgate.de
dtmf-relay sip-notify
####
clid network-number <???????>
###
!
!
sip-ua
credentials username 1234567t1password 7 xxxxx realm sipconnect.sipgate.de
authentication username 1234567t1password 7 xxxxx realm sipconnect.sipgate.de
no remote-party-id
registrar dns:sipconnect.sipgate.de expires 3600
sip-server dns:sipconnect.sipgate.de
!
christian
- Please rate helpful posts -
