cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
891
Views
0
Helpful
3
Replies

SPA 525g failed to get registered on CME

Remon Adel
Level 1
Level 1

Dear All,
I need your kindly help to get SPA525G phone registered with CME .
Kindly find attached running configuration of CME and output of commanf (Debug ccsip all) during phone failed registration.
I Set Phone as SIP not SCCP
SPA525g  (voice register dn 5,  voice register pool  5 & mac 547C.6949.3050 )


Thanks
Remon

3 Replies 3

Add below to the voice register pool 5 as this is missing in the config. Once done do a create profile. Try to delete and reconfigure the voice register pool if this does not work. Once done make sure to run create profile command under voice register global.

voice register pool 5
number 1 dn 5

Hope the user name and password are same on SPA as well. Try this and it should work.

HTH
Regards
Abhay

Kindly rate all helpful posts !!!
Regards
Abhay Singh Reyal
The Only Way To Do Great Work Is To Love What You Do. If You Haven’t Found It Yet, Keep Looking. Don’t Settle

unfortunality same issue ,
please check running config and  setting of SPA also debug commands attached

Thanks 

Check if the phone gets an IP address or not from the DHCP server, If it does perform below steps.
Step 1 :- Remove the VLAN config from the port and delete the phone from the CME. Remove Voice register pool for this
Step 2 :- Configure the phone again with the changes as advised in the last post and put the VLAN config back on the port where the phone is connected to.
Step 3 :- Run the command create profile under voice register global.

Collect the below debugs and output in case phone does not register
- debug ccsip messages
- debug tftp events
- show voice register tftp-bind
[If you can see the CNF file in the output run the command
more system:/cme/sipphone/SIPMAC_of_SPA.cnf.xml]
- show voice register all

Share the details and new show run again
HTH
Regards
Abhay
Regards
Abhay Singh Reyal
The Only Way To Do Great Work Is To Love What You Do. If You Haven’t Found It Yet, Keep Looking. Don’t Settle
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: