Hi
I would reconfig CCM so that it doesn't strip the 9, then set your dial-peers to
destination-pattern 9T
This would then work for both SRST calls and normal ones.
Otherwise, to keep the current setup, you would have to have two dial-peers for each one you have currently (one with and one without the 9). You may also get odd issues with overlaps of your internal extensions and some PSTN numbers/codes.
Secondary dial tone command just determines when the dial tone changes (i.e. when you press 9 in your command example)
Regards
Aaron
Please rate helpful posts..
Aaron
Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!