Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All, I have a scenario where I have a EX60 (home network) <-> VCS-E <-> VCS-C <-> EX60. We do have TMS, both units registered, if I dial e164 from external device or internal device call is successful BUT if the external device misses a call from i...
All, I have a layout with a call that is going to the following path PBX -> (wink trunk)H323-GW -> CM -> SIP -> Telco All my calls work perfectly with the following dial-peers below. The poroblem I have is when a user calls a number that starts wit...
I have a router that acts as an srst GW, the same router is the GW (h323). When in normal mode, the digits get sent to the GW and the CM strips the 9 but during SRST, the router handles call processing and rather than have dial peers with a 9 in fron...
I am having a problem with a site that is stating they get complaints of a busy signal when dialing a DID. I have looked at the call manager logs and CCDR and I don't seem to see anything. Is there a way for me to set up logging on an H323 gateway so...
All, I have read every doc on ethchannel and how it load balances traffic depending on src mac, ip l4port etc, I can not find any info on the command output for the show etherchannel detail command. What I am looking for is the load portion, at the ...
I know this post is old but you may be hitting a bug. I know I am hitting this bug, take a look and let me know if this is your problem.CSCta96039 Bug Details
THank you, I know the deug command and I can send that to a syslog but I was wondering if there was any type of stastics logging for voice that can be set up and captured so I can go to the GW and issue a command to see how many calls failed and pass...
You seem to have the nats on the ints correct, but you may need to deny traffic in the acl so you do not nat everything. WHat are you attempting? Is this a split tunnel or do you want all traffic to use the tunnel?
