cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
143
Views
0
Helpful
1
Replies

SSH 8851 advanced test key commands

CARLO CALABRESE
Level 1
Level 1

I am able to ssh to the 8851 just find and do a 'test key soft1' command just find.

But not able to the the advanced commands like 'test key set' or serv.

Is there something I am missing?

Is there something in CUCM that I need to enable to do these commands?

I have it working for 78XX and 79XX as will as the 8831s

1 Accepted Solution

Accepted Solutions

The ‘test key set’ or ‘serv’ commands are working on my 8841. Unfortunately, I don’t have an 8851, but I believe there shouldn’t be any difference since they all have the same firmware versions.

As far as I know, no additional settings are required on the CUCM for these commands to work.



Response Signature


View solution in original post

1 Reply 1

The ‘test key set’ or ‘serv’ commands are working on my 8841. Unfortunately, I don’t have an 8851, but I believe there shouldn’t be any difference since they all have the same firmware versions.

As far as I know, no additional settings are required on the CUCM for these commands to work.



Response Signature