Strange connectivity issues with CUE and NETWORK

[konstaninosoregano]

hello!

i have a 2811 router,with CME and a freshly install AIM-CUE.

my problem lies with the AIM-CUE.

i do not have connectivity from my lan (phones) to the cisco unity.

i can ping and reach the router,i can load cme gui...but i can not reach the cue.

so i tried something else. on my fa0/1, i assigned an ip of 10.0.0.1/24, and i plugged in a computer to that port, and after that i even enable rip v2.

from a pc with an ip of 10.0.0.5/25 i can reach ping the unity, i can load the unity gui!!

to make my problem simpiler, i can not reach unity from the network 192.168.1.0. but i can reach it from 10.0.0.0.

any ideas?

i am attaching my running-config!!

THANKS!!

[pcameron]

Paste these commands into the router config and give it another go -

interface fast ethernet 0/0

no ip redirects

no ip unreachables

no ip proxy-arp

[jlindler]

Don't you mean try these without the no's:

interface fast ethernet 0/0

ip redirects

ip unreachables

ip proxy-arp

(especially the ip proxy-arp)

[pcameron]

That's exactly what I meant, which is why I said paste the commands into the router so they were all removed :-)

[gracianogardunojr]

Konstanino,

In the unity what is the gateway address?

It should be 192.168.1.1also make sure you run

the CUE initialization wizard.Do you have two

Vlans created on switch?

Hope this helps

JR

[konstaninosoregano]

Hi guys,

thanks for youre replies, just got back to the office, and will try all your recommendations.

the gateway for the unity is 192.168.1.1.

i have run the init wizard...

i can reach the unity but from 10.0.0.1...

bizzarrrrrrrrr..

thanks

will let you know the outcome.

[konstaninosoregano]

hello again,

the removal of the no ip redirects,no ip proxy-arp, and no ip unreachable did the trick.

Thanks Guys!!