Trailing (1) at the end of device name

[al_vargas]

I have upgraded from CUCM 5.1.3 to 8.6.2.

Now all phone names are showing "(1)" at the end of their names, e.g. SEP0026B9B000F0(1)

Does someone know what that means?

Analog phones don't show the (1) at the end of name, only the IP phones and CIPC.

Regards,

Alberto

[Tracy Larson · Accepted solution]

It means that the DN is on line 1 that you searched for.

If you had two phones with the same DN on them and one of had that DN on line 2, then that particular phone would put a (2) at the end of the mac address I believe.

[al_vargas]

Tracy,

Thank you very much.

Regards,

Alberto

[Tracy Larson]

You are very welcome.