UC520 Busy out not In

[patrick.hurley]

I get a busy when I pick up the phone and dial 9 but I can call into the number.

[paolo bevilacqua]

Config problem, check your dial-peer.

[patrick.hurley]

Fixed it.

[paolo bevilacqua]

You don't have one, just the crap that the wizard puts in there.

Put lines actually connected in trunk-group

voice-port 0/1/2

trunk-group fxo

dial-peer voice 9 pots

destination-pattern 9T

trunkgroup fxo

The eliminate DPs 50 - 53, these are really useless.

Note, you cannot professionally configure UC520 without getting familiar with DPs, etc.

[paolo bevilacqua]

Edited...

[patrick.hurley]

My mistake. Meant to give you a 5. Is there any way to fix it?

Yes I was using the wizard, and I saw what I did wrong and did fix it. Thanks for your help.

[paolo bevilacqua · Accepted solution]

Mistakes can happen. Please check it is working for you and confirm.

You can rate any post you have not rated before, anytime.

[patrick.hurley]

Yes it works. I am testing the interface for a Cisco instructor. I was trying to be funny by pasting the whole thing in the post and saying "which one."

I found where it didn't have the right information and fixed it.

You are very helpful and thanks for being on Netpro!!