09-04-2012 06:22 AM - edited 03-16-2019 01:01 PM
Hi to all,
I have a small problem with this device:
Please if someone could help me with this.
Solved! Go to Solution.
09-04-2012 06:29 AM
When you do that, you create an FXO to FXO connection. In that case, the DSP must remain in the loop to detect disconnect tones. For that, have
voice-card 0
no local-bypass
Check if that improves the situation.
09-04-2012 06:29 AM
When you do that, you create an FXO to FXO connection. In that case, the DSP must remain in the loop to detect disconnect tones. For that, have
voice-card 0
no local-bypass
Check if that improves the situation.
09-04-2012 06:52 AM
Thanks a lot, I will try that and post the results.
Going a little further:
09-04-2012 07:51 AM
Voice-card is actually configuration for DSP, where the commands applies.
And, disconnect signal rarely works because telco do not support it. Only accurate tone configuration works.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide