UK E1 PRI

[Rajesh Revuru]

Hello:

When adding E1 PRI for UK using MGCP what would be the PRI protocol type?

Thanks

[Rob Huffman · Accepted solution]

Hi Rajesh,

Hope all is well! You should check with the Service Provider but it may well be;

isdn switch-type primary-net5

Hope this helps!

Rob

[Rajesh Revuru]

Rob:

All is good, thanks for the information,

for be the "PRI protocol type" in the CUCM GUI page. Currently have following options and i guess it would be PRI-EURO

1. PRI EURO

2. PRI Australian

[Steellllllllll0 · Accepted solution]

Hi,

I normally use PRI euro and never had any problems so far touch wood...

[Rob Huffman]

Hi Rajesh,

Sorry for the delay, I missed your reply completely :(

"PRI - EURO" should be just fine as nicely stated by Bruce. (+5 points for your good work here Bruce)

Take care buddy!

Rob

[Rajesh Revuru]

Rob & Bruce:

Thanks for your input.