Unable to add smart license to CUC 12.5

[donald.martinez.4]

I am currently running CUC 12.5 and I am having problems licensing with CLI commands.

admin:license smart authorization install "<authorization code>" enter <specificPLR>...

Any help on how this should be enter, I get the error:

Expected 1 mandatory and up 0 non-mandatory parameter(s)

but 14 parameter(s) were found

Executed command unsuccesfully

Error executing command

[Roger Kallberg]

Probably a lot easier to do the setup/connection of smart licensing from the webUI instead of from the CLI. There you basically just set the url to your on-prem SSM, if you have it, and then use a token created in SSM to have the system connect to it.

[donald.martinez.4]

Unfortunately, my CUC 12.5 is part of a enclosed network.  I do not have the option to set the url.  I absolutely not sure if I am inputting the commands correctly.

[Jaime Valencia]

Have you reviewed the CLI reference guide?

All the commands and how to use them are explained in there.

[Roger Kallberg]

Are you sure your using the correct command? From what I could tell on our 12.5 CUCs these are the license commands.

If you where to setup the connection to SSM I think the command to use would be license smart register idtoken token_id [force]

[donald.martinez.4]

admin:license smart reservation install....then when inputting the license it errors out.

[Roger Kallberg]

Have a look at this presentation from ciscounitytools.com about CUC and SL.