Unable to configure new E1 card

[simonmossman]

Hi all

Please help as I am having problems configuring a new E1 card. I can see it in the sh diag but it will not let me enter the controller E1 0/1/0 as I have another in 0/0/0? What am I missing as I have set this up in CUCM 5.0 as E1 MGCP?

[appserv · Accepted solution]

Have you specified the card type?

card type e1 0 1

[simonmossman]

I know this is slightly late haha....... I was entering the card type slot info incorrectly