cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
919
Views
0
Helpful
0
Replies
will.alvord
Contributor

VG204 sccp to paging zone device

We have a vg204 configured as a sccp gateway with 1 sccp analog phone configured.  The corresponding fxs port is connected to a Valcom paging system.  When a buttset is directly connected to the Valcom device, we get a second dialtone as expected and can press 0 for all zones, or 1 through whatever to page specific zones.  After inputting a zone number or 0 for all, you hear a tone and can begin the page.

When dialing the directory number on the sccp analog phone, the paging system device picks up but there's no dialtone...just the tone and a hot mike to all of the paging zones.  It's as if CUCM is sending an extra 0 to hit all the zones.

None of my debugs have captured anything useful looking, and it's sccp...so not much in the way of configs.  Any ideas?

thanks,

will

0 REPLIES 0
Create
Recognize Your Peers
Content for Community-Ad