Hello Community, may be it gives a solution :-)
The goal is to Plug in a New VG20x in Power and network and setup first config via IP Remote, not w/ console
Problem is some VG20x runs in a initial Setup, some VG20x runs directly in prompt and get an IP, but is no password set for VTY. So all the time first config only possible via Serial Console cable.
We would send the new VG20x to the customer. The Customer plug in to network and power and we could configure via Remote.
Why some VG runs in initial setup? Get they also an IP? And why some VG runs w/o initial Setup in prompt and get an IP?
HW or FW depend?
Is there any way to setup the first config only with remote?