VG224 SCCP and HuntGroup on CCM 6.1

[Stefano Amici]

Hi all,

i configured a VG224 SCCP gateway on CCM 6.1; all features work fine on analog phone except hunt group. If I configure an analog phone as member of hunt group it doesn't ring. I tried to reset it, to remove and add several times but with no success.

Any ideas?

Thanks in advance,

Stefano

[hanson.stanley]

Hi,

I am sorry if i am disturbing you..but im completely stuck with this...Can you help me....????

I am trying to configure a VG224 with a CCME3.3 router.I need call transfer facility from analog phones that r connected to this VG224.I am configuring VG224 as a SCCP gateway.

i have tried to configure sccp in VG224.what i have done in VG224 is ;

#conf t

#sccp local

#sccp ccm identifier 1 version 3.3

#sccp

#sccp ccm group

#associate ccm 1 priority 1

#exit

When i have typed the "#show sccp" command;

this message shows....

"sccp parameters are not activated (dspfarm profiles)or not associated with ccm group"

I have dsp module in CCME router..

then i came to know that dsp farms r to be created and to be associated to the ccm group...

I have gone through the materials..but still i have doubt on integrating...

Can anyone please help me with the detailed configuration??

I am stuck with this..

please please please help me with this....

Thanks in advance.............

[DANIEL COHEN-LAROQUE]

Hello Stefano,

I just face same problem, but with a 2800 IOS using stcapp feature (same as VG224).

By this time, have you found out the problem?

[Stefano Amici]

Hi,

I'm sorry but I didn't solve the issue; I found a workaround using an ATA to connect that analog phone.

Stefano

[agster.bt]

Hi,

The VG224 ports are "logged out" of Hunt Groups by default.

If you put a tick in the "Logged into Hunt Group" box at the Device Level on the VG224 that will fix it.

Kind Regards

Andrew