Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
We have incoming calls going to a CUBE then via H323 to call manager when calls are forwarded to unity and then the caller presses a key in a call handler the user hears the transfer music for a second or two then dead silence until the intended part...
Hi,Is it possible to do a 3 conferencing using a CUCM ?i.e after calling one person, I call another person using the conference adhoc and both will be in conference with me.thks.
Hi there !I'd like to change the logo of ip phone 7911... there's a Cisco logo and I'd like to use my company's logo...I tryied this link.. but it's not what I want because I don't want my logo only while the ip phone is idle... I want my logo istead...
Hello,one of our customers plans to connect alcatel ip phones "ip touch 4038" (with pcs connected to the phones) to cisco Cat4500 switches. Also normal pcs should be connected directly to the 4500.So I think the phones would be connected with vlan tr...
Hi all,i configured a VG224 SCCP gateway on CCM 6.1; all features work fine on analog phone except hunt group. If I configure an analog phone as member of hunt group it doesn't ring. I tried to reset it, to remove and add several times but with no su...
Hi,we are having a callmanager set up in which we have configured hunting on the reception phone. Now if a call comes from PSTN and the operator doesn't answer that call it will be hunted to another number, like that we have 5 extensions in the hunt ...
Howdy,Is it possible to send calls from a Cisco Phone to CCM then out to a cisco gateway (2800) then across to another cisco gateway (2800) and back into Call Manager?I've tried everything but Call Manager wont accept the inbound call unless it comes...
Version Information:=====================c2800nm-spservicesk9-mz.124-11.XJ.bin========================================The issue is that when the night service bell is activated and then deactivated on a 7970 phone, that phone's call forward option is...
CCME 4.1 integrate with CCM 4.2 as a h.323 gateway. Need to use g.729 for inter-site voip calls and g.711 for calls within local subnet. Now I configure a different region for CCME and choose codec g.729 to CCM region. Transcoder is configured only i...
The default setting for inside dial tone timeouts is 16 second, is it possible to extend the dial tone timeouts value? Please give example
hi friends do you know which cipc software is available for mac laptop.Regardssunny
Dear All,I need to implement AAR. There are two separate clusters connected by Intercluster trunk Is it possible in this scenario ?
Q1 In the scenario, where you have all incoming PSTN calls coming into 1 site and then being routed across the wan(G.729) to the relevant user.How would the transcoding work in this scenario? Usually you would terminate a TDM with a G.711 packet.but ...
I need advice on a design. If you have a remote site on a centralised model, and the Wan link is on a seperate router to the Voice gateway. Would you just configure 1 gateway in UCCM(6.1) and point the relevant digits to the voicegateway and then cr...
Hi All, I'm planning on upgrading to release 6.1(2)SU1a per Field Notice 63174. The upgrade is pretty straight forward upon reading Cisco Unified Operating System Administration Guide, under the software upgrade. However, there is small piece per the...
