Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
408
Views
0
Helpful
2
Replies

VG310 to register stcapp with CUCME on 4331

VON CLAWSON
Level 3
Level 3

‎08-02-2018 06:37 PM - edited ‎03-18-2019 12:29 PM

I'm trying to register the fxs ports on a VG310 to CUCME on 4331.  Telephony-Service has been configured but I cannot configure the voice-gateway system command. Is there some other command that I need to set to get this to show up?

Please rate if this helps.
Labels:
0 Helpful
2 Replies 2

R0g22
Cisco Employee
Cisco Employee

‎08-03-2018 09:03 AM

Can you share the config for both the routers ?

0 Helpful

UDozie
Level 1
Level 1

‎05-16-2019 06:58 AM

Von, I am also having the same issue, where you able to get an answer to this?

0 Helpful
Customers Also Viewed These Support Documents