cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
384
Views
0
Helpful
1
Replies

VG320 SCCP Config

Mark Dragone
Beginner
Beginner

Hi All

I have a question regarding a VG320 programmed as SCCP.  Whenever the VG320 is reloaded, due to power failure or whatever, the "stcapp feature speed-dial" returns in the programming of the gateway.  I then need to go in and issue the "no stcapp feature speed-dial" command in order to once again disable it as i do not want it enabled.  Wr mem is always done after making the change.  Any thoughts as to why this would be happening.

1 Reply 1

Rob Huffman
Hall of Fame Community Legend Hall of Fame Community Legend
Hall of Fame Community Legend

Hi Mark,

I did see a similar thread with a good response from Tere @Cisco;

https://supportforums.cisco.com/discussion/11794771/vg224-disable-stcapp-feature-speed-dial

Cheers!

Rob

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers