VG320 SCCP Config

[Mark Dragone]

Hi All

I have a question regarding a VG320 programmed as SCCP.  Whenever the VG320 is reloaded, due to power failure or whatever, the "stcapp feature speed-dial" returns in the programming of the gateway.  I then need to go in and issue the "no stcapp feature speed-dial" command in order to once again disable it as i do not want it enabled.  Wr mem is always done after making the change.  Any thoughts as to why this would be happening.

[Rob Huffman]

Hi Mark,

I did see a similar thread with a good response from Tere @Cisco;

https://supportforums.cisco.com/discussion/11794771/vg224-disable-stcapp-feature-speed-dial

Cheers!

Rob