03-06-2011 07:25 PM - edited 03-16-2019 03:49 AM
I am setting up a very simple ip phone connection using the VIC-4FXS/DID card. I have it setup and working now using the following config, however i would like to have it auto dail (hotline) as soon as phone goes offhook. How can this be configured. it is used between t locations for tech use only on a private cloesed network.
Router 3845-1
dial-peer voice 1 pots
destination-pattern 1234
port 1/0/0
dial-peer voice 1000 voip
destination-pattern 5678
session-tartget:192.168.1.1
codec g711ulaw
Router 3845-2
dial-peer voice 2 pots
destination-pattern 5678
port 1/0/0
dial-peer voice 2000 voip
destination-pattern 1234
session-tartget:192.168.2.1
codec g711ulaw
Solved! Go to Solution.
03-07-2011 04:46 AM
If your phone is connected to one of the FXS ports (say 1/0/1)
the configure:
voice-port 1/0/1
connection plar
make sure you have a dial-peer to whatever number will be dialed from the tech handset
03-07-2011 04:46 AM
If your phone is connected to one of the FXS ports (say 1/0/1)
the configure:
voice-port 1/0/1
connection plar
make sure you have a dial-peer to whatever number will be dialed from the tech handset
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide