07-03-2018 02:04 AM - edited 03-18-2019 12:27 PM
Hello all,
I have a cisco ISR 4321 , i would configure E1 , but the port 0/1/0:15 not diplayed in gateway.
you can receive the config below.
can you help me please
Best regads
Akram
Solved! Go to Solution.
07-03-2018 05:00 AM
Hi,
can u try the command under controller E1and check.
pri-group timeslots 1-31 voice-dsp
regds,
aman
07-03-2018 02:46 AM - edited 07-03-2018 04:00 AM
Hi @akram.root
You have got this message on your sh run config @akram.root:
! card type command needed for slot/bay 0/1
Please @akram.root check the gw-isr4431-1.txt file that you have posted first.
Just above your enable password Didata2018 command you have:
! card type command needed for slot/bay 0/1
I don't see any controller e1 also.
Do you configure card type e1 command? And after configure the controller interface.
07-03-2018 03:09 AM
thank you for your reply ,
i not have this message on sh run
card type command needed for slot/bay 0/1
i configured card type e1 command and controller interface but d'ont work
07-03-2018 03:38 AM - edited 07-03-2018 03:41 AM
Hi Akram,
You have available PRI E1/T1 slot and I can see you have configured the e1 controller.
You need to create the pri-group under the controller.
Isdn switch-type primary-ni
Controller e1 0/1/0
pri-group timeslots 1-
Please refer the discussion :
https://supportforums.cisco.com/t5/ip-telephony/voice-ports-not-showing-up-on-isr-router/td-p/2053084
Regards
Prassha3
Rate if you find this helpful
07-03-2018 03:49 AM
thank you for your reply
I tested but not displayed voice-port 0/1/0:15
Best regards
07-03-2018 04:04 AM
I have configured
card type e1 0 1
best regrds
07-03-2018 04:05 AM
yes i configured e1 after i configured controller e1
best regards
07-03-2018 04:09 AM
07-03-2018 03:00 AM - edited 07-03-2018 03:01 AM
Hi Akram,
Let me know if you are able to set the card type and controller type. If not can you share the output for show controller and show inventory.
eg : card type e1 0:15
controller e1 0:15
You can refer the document for configurations :
Regards,
Prassha3
Rate if you find this helpful
07-03-2018 03:16 AM
07-03-2018 05:00 AM
Hi,
can u try the command under controller E1and check.
pri-group timeslots 1-31 voice-dsp
regds,
aman
07-03-2018 06:43 AM
yhank you very much
it is displayed now
thank you for your help
Best regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide