cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
525
Views
15
Helpful
1
Replies

voice port keeps ringing after disconnect

Vijay Anand
Level 1
Level 1

hi all,

i have strange situtation, i have a cme configured with sip deskphone and SCCP wireless phone in a hunt group.

pilot 3527 ------- --- CME ----------------- FXS/FXO---------ISDN -----------------mobile

for incoming call it hits the FXO port and after 6 rings call is hitting the pilot and ring the phone. but if remote phone hangs up, deskphone keeps ringing and have to manully disconnect it. and caller id is also not working showing as unknown number.

i am not sure what i am missing in config.. Please help!!!!

looking at voice port summary ..... there is a link detection but phone show onhook

attached 

config

and debug

1 Reply 1

Brandon Buffin
VIP Alumni
VIP Alumni

See the following link for an explanation of and several solutions to common FXO disconnect problems.

http://www.cisco.com/c/en/us/support/docs/voice/analog-signaling-e-m-did-fxs-fxo/8120-fxo-disconnect.html

Brandon