10-21-2010 07:09 AM - edited 03-16-2019 01:28 AM
Dear All
Today I encountered an issue with a voip dial-peer
With no configuration change, the dial-peer went into down/down status.
Does anyone know what circumstances would cause this?
To be clear, the dial-peer was not shut via CLI
Thanks
Phil
10-21-2010 07:16 AM
Are u able to share this voip dialpeer along with sh dial peer voice summ output?
Wondering if you have a ping or busy out feature configured that can take down a
dialpeer dynamically if u lose network connex.
10-21-2010 07:36 AM
sure, thanks for looking at this.
This is it now after I did a no shut on the dial-peer
ROUTER#sh dial-peer voice summary
dial-peer hunt 0
AD PRE PASS OUT
TAG TYPE MIN OPER PREFIX DEST-PATTERN FER THRU SESS-TARGET STAT PORT
190000 voip up up 190[1,3-9]... 0 syst ipv4:1.1.1.1
190200 voip up up 1902... 0 syst ipv4:2.2.2.2
91900 pots up up 9190T 0 up 3/0:15
91901 pots up up 9190T 0 up 3/1:15
ROUTER#sh dial-peer voice summary
dial-peer hunt 0
AD PRE PASS OUT
TAG TYPE MIN OPER PREFIX DEST-PATTERN FER THRU SESS-TARGET STAT PORT
190000 voip up up 190[1,3-9]... 0 syst ipv4:1.1.1.1
190200 voip down down 1902... 0 syst ipv4:2.2.2.2
91900 pots up up 9190T 0 up 3/0:15
91901 pots up up 9190T 0 up 3/1:15
config is:
dial-peer voice 190200 voip
description UNMIS Juba
max-conn 15
destination-pattern 1902...
progress_ind setup enable 3
progress_ind connect enable 8
signaling forward unconditional
session target ipv4:10.130.176.110
dtmf-relay h245-alphanumeric
codec g729r8 bytes 40
fax-relay ecm disable
fax rate 7200
fax nsf 000000
fax protocol cisco
ip qos dscp cs5 media
ip qos dscp af41 signaling
!
10-21-2010 07:38 AM
ah, one thing I noticed. I have a max-conns on this dial-peer. If we reached the 15 calls would the dial-peer shows as down/down?
10-21-2010 08:24 AM
No, I don't think once u hit configured max-conn, the dialpeer admin and oper status
should go down. What you would see is a msg similar to following in the logs...
%CALL_CONTROL-6-MAX_CONNECTIONS: Maximum number of connections reached for dial-peer
There is something else going on which is taking that voip dialpeer down and don't think
its the max-conn CLI.
What do u see for sh dial-peer voice
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide