02-19-2020 12:43 AM
Hi Cisco Community !
I just wanna know when a computer "the system actually" configured with two version of ip (4 and 6) .
Does the computer choose automatically the type of @ based on what destination adresse version like that,? or there is some more infos you can help me know 'em,
Thanks in advance :)
Solved! Go to Solution.
02-19-2020 12:51 AM
Depends on Operating system, since IPv6 not fully available, people mostly configure IPv4 over IPV6 preferred
Some cases may not be the same, if the organization ready with IPv6 and dual-stack available in the environment, they can use IPv6
it's all how you designed the network, who handover the IP address on the network layer?
make sense ?#
02-19-2020 12:51 AM
Depends on Operating system, since IPv6 not fully available, people mostly configure IPv4 over IPV6 preferred
Some cases may not be the same, if the organization ready with IPv6 and dual-stack available in the environment, they can use IPv6
it's all how you designed the network, who handover the IP address on the network layer?
make sense ?#
02-19-2020 02:57 AM
may be i didn't say much / u get me wrong .
but the thing is simple , a Network Card with two ip @ use one of them based on destination ip @ that all 'I think'
correct me if so :)
02-19-2020 04:02 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide