cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3494
Views
0
Helpful
1
Replies

IPv6 ra nd no-onlink support - which IOS version?

grantmericle
Beginner
Beginner

According to the IOS command guide, no-onlink support was added in this release:

12.2(32.08.01)REC154  The no-onlink keyword was added.

The full command would be:

ipv6 nd prefix ipv6-prefix/prefix-length valid-lifetime  preferred-lifetime [off-link| no-rtr-address | no-autoconfig| no-onlink]

I can't find that specific IOS image, so I installed  12.2(33)SRD8.     This release still doesn't have no-onlink integrated.  How can I determine what available IOS version I need to get the no-onlink support?

Thanks, 

  Grant

1 Accepted Solution

Accepted Solutions

SunilKhanna
Beginner
Beginner

Grant,

I checked it on IOS  Version 15.1(3)S3.

I am not sure, if you have tried Cisco Feature Navigator Tool.

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

PS: Please rate the post if you find the content helpful.

Regards,

Sunil.

Regards, Sunil Khanna

View solution in original post

1 Reply 1

SunilKhanna
Beginner
Beginner

Grant,

I checked it on IOS  Version 15.1(3)S3.

I am not sure, if you have tried Cisco Feature Navigator Tool.

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

PS: Please rate the post if you find the content helpful.

Regards,

Sunil.

Regards, Sunil Khanna
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers