cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2597
Views
1
Helpful
3
Replies
ROMAN TOMASEK
Beginner

OSPFv3 IPSec authentication on Catalyst4900M

Hi all,

do you have any information when the OSPFv3 IPSec authentication will be supported on Catalyst 4900M? Thank you.

Roman

1 ACCEPTED SOLUTION

Accepted Solutions
Harold Ritter
Cisco Employee

Roman,

This is supported from 15.1(1)SG. It requires a crypto image of course.

Hope this helps

Harold Ritter
Sr Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México

View solution in original post

3 REPLIES 3
Julio Carvajal
Advisor

Hello Roman,

I do not have access to any 4900M at the moment but you sure you cannot run it in the 15.1(2)SG release?

I mean if OSPFv3 it's supported on the IOS then you should have the hability to configure authentication, it's embedded on the protocol.

Now what I suspect the problem is... Is that you do not have a crypto image so then you cannot configure IPSec,

Make sure you are running a Crypto IOS image and you should be good to go

Regards,

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
Harold Ritter
Cisco Employee

Roman,

This is supported from 15.1(1)SG. It requires a crypto image of course.

Hope this helps

Harold Ritter
Sr Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México

View solution in original post

Thank you very much. Roman