cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3798
Views
1
Helpful
3
Replies

OSPFv3 IPSec authentication on Catalyst4900M

ROMAN TOMASEK
Level 1
Level 1

Hi all,

do you have any information when the OSPFv3 IPSec authentication will be supported on Catalyst 4900M? Thank you.

Roman

1 Accepted Solution

Accepted Solutions

Harold Ritter
Spotlight
Spotlight

Roman,

This is supported from 15.1(1)SG. It requires a crypto image of course.

Hope this helps

Regards,
Harold Ritter, CCIE #4168 (EI, SP)

View solution in original post

3 Replies 3

Julio Carvajal
VIP Alumni
VIP Alumni

Hello Roman,

I do not have access to any 4900M at the moment but you sure you cannot run it in the 15.1(2)SG release?

I mean if OSPFv3 it's supported on the IOS then you should have the hability to configure authentication, it's embedded on the protocol.

Now what I suspect the problem is... Is that you do not have a crypto image so then you cannot configure IPSec,

Make sure you are running a Crypto IOS image and you should be good to go

Regards,

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC

Harold Ritter
Spotlight
Spotlight

Roman,

This is supported from 15.1(1)SG. It requires a crypto image of course.

Hope this helps

Regards,
Harold Ritter, CCIE #4168 (EI, SP)

Thank you very much. Roman