cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2552
Views
1
Helpful
3
Replies
ROMAN TOMASEK
Beginner

OSPFv3 IPSec authentication on Catalyst4900M

Hi all,

do you have any information when the OSPFv3 IPSec authentication will be supported on Catalyst 4900M? Thank you.

Roman

1 ACCEPTED SOLUTION

Accepted Solutions
Harold Ritter
Cisco Employee

Roman,

This is supported from 15.1(1)SG. It requires a crypto image of course.

Hope this helps

Harold Ritter
Sr Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México

View solution in original post

3 REPLIES 3
Julio Carvajal
Advisor

Hello Roman,

I do not have access to any 4900M at the moment but you sure you cannot run it in the 15.1(2)SG release?

I mean if OSPFv3 it's supported on the IOS then you should have the hability to configure authentication, it's embedded on the protocol.

Now what I suspect the problem is... Is that you do not have a crypto image so then you cannot configure IPSec,

Make sure you are running a Crypto IOS image and you should be good to go

Regards,

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
Harold Ritter
Cisco Employee

Roman,

This is supported from 15.1(1)SG. It requires a crypto image of course.

Hope this helps

Harold Ritter
Sr Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México
Paseo de la Reforma 222
Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México

View solution in original post

Thank you very much. Roman

Content for Community-Ad
This widget could not be displayed.