Unable to select tunnel mode ipv6ip

[JiriKanicky_2]

Hi.

Please, can you explain why I am not able to select tunnel mode "ipv6ip" on my switch. I would like to configure tunnel from Hurricane tunnelbroker.net.

switch-cisco-lab-cor(config-if)#tunnel mode ?
  aurp    AURP TunnelTalk AppleTalk encapsulation
  cayman  Cayman TunnelTalk AppleTalk encapsulation
  dvmrp   DVMRP multicast tunnel
  eon     EON compatible CLNS tunnel
  gre     generic route encapsulation protocol
  ipip    IP over IP encapsulation
  iptalk  Apple IPTalk encapsulation
  ipv6    Generic packet tunneling in IPv6
  nos     IP over IP encapsulation (KA9Q/NOS compatible)
switch-cisco-lab-core#show running-config interface tunnel 0
Building configuration...
Current configuration : 203 bytes
!
interface Tunnel0
 description Hurricane Electric IPv6 Tunnel
 no ip address
 shutdown
 ipv6 address 2001:xxx:xxxx::2/48
 ipv6 enable
 tunnel source 172.16.1.1
 tunnel destination xxx.xxx.xxx.xxx
end
Switch Ports Model              SW Version            SW Image                 
------ ----- -----              ----------            ----------               
*    1 52    WS-C3560G-48TS     12.2(53)SE            C3560-IPSERVICESK9-M

[Laurent Aubert · Accepted solution]

Hi,

You need Advanced IP services feature set for IPv6 in IPv4 tunneling feature support.

HTH

Laurent.

[JiriKanicky_2]

Hi.

Does this mean that I need to update the image?

[Laurent Aubert]

Correct as you are currently using IP Services feature set.

[JiriKanicky_2]

Hi Laurent.

Thank you!