11-07-2011 05:12 PM - edited 03-01-2019 05:30 PM
Hi.
Please, can you explain why I am not able to select tunnel mode "ipv6ip" on my switch. I would like to configure tunnel from Hurricane tunnelbroker.net.
switch-cisco-lab-cor(config-if)#tunnel mode ?
aurp AURP TunnelTalk AppleTalk encapsulation
cayman Cayman TunnelTalk AppleTalk encapsulation
dvmrp DVMRP multicast tunnel
eon EON compatible CLNS tunnel
gre generic route encapsulation protocol
ipip IP over IP encapsulation
iptalk Apple IPTalk encapsulation
ipv6 Generic packet tunneling in IPv6
nos IP over IP encapsulation (KA9Q/NOS compatible)
switch-cisco-lab-core#show running-config interface tunnel 0
Building configuration...
Current configuration : 203 bytes
!
interface Tunnel0
description Hurricane Electric IPv6 Tunnel
no ip address
shutdown
ipv6 address 2001:xxx:xxxx::2/48
ipv6 enable
tunnel source 172.16.1.1
tunnel destination xxx.xxx.xxx.xxx
end
Switch Ports Model SW Version SW Image
------ ----- ----- ---------- ----------
* 1 52 WS-C3560G-48TS 12.2(53)SE C3560-IPSERVICESK9-M
Solved! Go to Solution.
11-07-2011 07:43 PM
Hi,
You need Advanced IP services feature set for IPv6 in IPv4 tunneling feature support.
HTH
Laurent.
11-07-2011 07:43 PM
Hi,
You need Advanced IP services feature set for IPv6 in IPv4 tunneling feature support.
HTH
Laurent.
11-07-2011 07:55 PM
Hi.
Does this mean that I need to update the image?
11-07-2011 07:57 PM
Correct as you are currently using IP Services feature set.
11-07-2011 07:59 PM
Hi Laurent.
Thank you!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide