03-25-2010 07:20 PM
Hi
I have requirement like below
--------------Ethernet Point-to-Point Leased Line1------------------
--------Trunk-------- 2911 Router 2911 Router-------Trunk-------------
--------------Ethernet Point-to-Point Leased Line2-------------------
I am planning to use existing onboard 3 10/100/1000 ports in 2911 router for one trunk and etherchannel configuration. Trunk connects to local lan and etherchannel conncts to remote branch. My doubt is can I configure 2911 onboard ports as trunk and implement etherchannel? As of now there will be no routing configuration in 2911.
Regards
Siva K
Solved! Go to Solution.
03-26-2010 06:54 AM
Hello Siva,
>> As of now there will be no routing configuration in 2911.
use a LAN switch for this or an etherswitch module installed in the C2911 routers
routed ports can be used only as routed ports or for bridiging (IRB) you cannot configure them as L2 trunks, you may use them as a L3 port-channel but not as a L2 trunk port-channel.
Hope to help
Giuseppe
03-26-2010 06:54 AM
Hello Siva,
>> As of now there will be no routing configuration in 2911.
use a LAN switch for this or an etherswitch module installed in the C2911 routers
routed ports can be used only as routed ports or for bridiging (IRB) you cannot configure them as L2 trunks, you may use them as a L3 port-channel but not as a L2 trunk port-channel.
Hope to help
Giuseppe
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide