02-14-2020 08:13 AM
Hello,
I have a weird problem.
I set up 6PE using an old ASR1000 as route-reflector. (IOS XE version 03.16.09.S).
The RR eceive prefixes from 6PE enable routers and reflect them correctly.
If I try to configure an outgoing route-map to a specific peer the RR stop sending prefixes to this last peer.
I see that prefixes are all dropped:
Outbount Inbound
Local Policy Denied Prefixes: -------- -------
Other Policies: 1 n/a
Invalid Labels: 6 n/a
Total: 7 0
The route-map is matiching either community and ipv6 prefix-list
What I'm wrong ?
Davide
Solved! Go to Solution.
03-09-2020 06:51 AM
Hello Elvin,
I resolved the issue. I was missing a specific "set" into route map:
Here's the output:
!
route-map 6PE-PADOVA-OUT permit 10
match community PE-PADOVA-LB
set mpls-label
!
03-09-2020 07:23 AM - edited 03-09-2020 07:55 AM
What I was expecting ; ). If you set a route-map policy, the label is not set by default, and the device will drop the update.
Good to know all is solved now.
Elvin
03-09-2020 06:16 AM
03-09-2020 06:51 AM
Hello Elvin,
I resolved the issue. I was missing a specific "set" into route map:
Here's the output:
!
route-map 6PE-PADOVA-OUT permit 10
match community PE-PADOVA-LB
set mpls-label
!
03-09-2020 07:23 AM - edited 03-09-2020 07:55 AM
What I was expecting ; ). If you set a route-map policy, the label is not set by default, and the device will drop the update.
Good to know all is solved now.
Elvin
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide