MPLS

Hi,Is there a way to automatically map routes to different TE tunnels based on some criteria like BGP communities for example?I know we can map them based on CoS using CBTS, but can we do it based on communities?In Juniper this can be done using "ins...

I have the following L3VPN topology (https://imgur.com/a/B1bd94Z). VRF CUST-A is configured on the PE routers. I also have mp-bgp neighborship from R1/R2 towards RR (R3). I am not able to ping from 9.9.9.9 towards 10.10.10.10 R9 can see the loopback ...

Dears, Could you please advise on how can i modify the next hop of customer A & B so when they leak routes to each other the next hop can be reachable ? they are currently use the same address space and they can see the loopbacks of each other alread...

hi, Im having problems passing traffic with mtu above 1500 and df activated through l2vpn connection. this is the configuration on both sides: 36X-PE1# sh run int vlan1617interface Vlan1617description PE1mtu 1600ip address 10.169.84.2 255.255.255.248...

Dear all, I would like to ask you whether this is a valid MPLS Core design with two RRs, also should the two RRs include MPLS configuration as well? Thank you in advance for all comments and suggestions.

Dear all, I think currently Cisco's major SR supported product is IOS-XR right?Because there is a lot of configuration examples easy to understand and some dCloud scenario which normally IOS-XR configuration and operation. However in my understanding...

Hi, I am getting this error log, do any of you had this log in their routers, i was trying to findout the rootcause but could not find much and could not able to decode the tracebacks on this issue. BG: %C6K_MPLS_RP-3-INVALID_OBJECT: Invalid objectc6...

Hi, I'm trying to set-up bgp vpnv4 between different AS:Cust_Site_A-->AS10-->AS11-->AS12-->Cust_SIte_B Between AS10 and AS11 it's Inter-AS option C (Labeled-unicast between the ASBRs, and VPNv4 between the RRs)I'm receiving Cust_Site_A prefixes with ...

Hi All, I am working for a Tier-1 service provider who is planning to migrate their existing transport network to a seamless MPLS architecture using BGP-LU However, they are concerned that their routers in access layer will be overloaded with too man...

Olá comunidade! Alguém saberia me informar se é possível atrelar uma VRF à uma VPLS?No cenário, possuo um backbone em MPLS, e preciso fazer com que dois sites de um mesmo cliente se comuniquem por uma VRF, de forma a separar as tabelas de roteamento....

So, in an effort build a sham link lab setup I have the following setup: PE1 ----- CE1 running OSPF in VRF VPN_APE2 ----- CE2 running OSPF in VRF VPN_APE1 is IOSPE2 is XR There is a backdoor link from CE1 to CE2.PE1 and PE2 have a BPG vpnv4 connectio...