07-31-2018 04:18 AM
Hi guys,
I'm about to deploy A-VPLS and it's the first time. I've working with VPLS (traditional Configuration) and with the A-VPLS configuration I'm getting a bit confused.
Let's say I have this configuration (same as config guide)
pseudowire-class cl1 encap mpls load-balance flow flow-label enable ! port-channel load-balance src-mac ! interface virtual-ethernet 1 transport vpls mesh neighbor 10.2.2.2 pw-class cl1 neighbor 10.3.3.3 pw-class cl1 switchport switchport mode trunk switchport trunk allowed vlan 10, 20
How do I know which interface to patch the customer to, in chassis.
The regular configuration we bind it to a BDI and maybe to a service instance, but in this case I don't see it.
I also don't have the platform to test it before deploying on the customer, so I'm trying to figure this out before that.
Thank you
BR
Ruben
Solved! Go to Solution.
07-31-2018 10:06 AM
Hi Ruben,
You just need to configure the access port with the proper VLAN and it will get trunked over A-VPLS.
Regards,
07-31-2018 10:06 AM
Hi Ruben,
You just need to configure the access port with the proper VLAN and it will get trunked over A-VPLS.
Regards,
08-01-2018 02:21 AM
Thank you,
It makes sense though, but it seems strange that a mpls service is on the routing base, and not in an overlay like l3vpn.
Will try this tomorrow.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide